PL and IC: ice pellets and ice crystals in METAR and TAF

Tafrob editorial team · Updated · 6 min read

Short answer

PL is ice pellets: hard, transparent or translucent grains of ice, 5 mm or less, formed from frozen raindrops or largely melted and refrozen snowflakes. They can signal freezing rain at higher levels. PL takes an intensity sign. IC is ice crystals, also called diamond dust: unbranched needles, columns or plates. IC never takes an intensity sign.

Key points

  • PL is ice pellets: hard, transparent or translucent ice grains of 5 mm or less.
  • WMO-No. 782 and CAP 746 state that ice pellets can indicate supercooled or freezing rain at higher levels.
  • FMH-1 sets PL intensity by rate of fall or, by eye, from accumulation and visibility.
  • FMH-1 and NWS Instruction 10-813 allow SHPL; WMO-No. 782 states that SH cannot be used with PL.
  • IC is ice crystals (diamond dust): unbranched needles, columns or plates, with no intensity sign.
  • In US practice, a SPECI is required when ice pellets begin, end or change intensity.
Small translucent ice pellets scattered on a blue surface next to a US one cent coin for scale
Photo: Runningonbrains, Public domain, via Wikimedia Commons

Two frozen codes with different stories

PL and IC are both ice, but they form in very different ways and carry different messages for a pilot. Ice pellets are raindrops or snowflakes that have melted and refrozen on the way down, which says something about the air above the aerodrome. Ice crystals, by contrast, are unbranched crystals that FMH-1 describes separately from snow. Both are coded in the present weather group.

Code Meaning
-PL Light ice pellets
PL Moderate ice pellets
+PL Heavy ice pellets
SHPL Ice pellet showers (US rules only)
TSPL Thunderstorm with ice pellets (US rules)
IC Ice crystals, no intensity

Ice pellets: what they are

FMH-1 defines ice pellets as hard grains of ice consisting of frozen raindrops, or largely melted and refrozen snowflakes. They are transparent or translucent, round or irregular, rarely conical, with a diameter of 0.2 inch (5 mm) or less. CAP 746 (section 4.84) adds that they fall from deep stratiform cloud, bounce with an audible sound on impact and are not easily crushed. WMO-No. 782 gives the same picture: transparent or translucent particles that cannot be crushed easily, 5 mm or less across.

The image on this page shows ice pellets next to a one cent coin, which is 19 mm across: the pellets are a few millimetres each.

Why PL is a warning

The way ice pellets form is the reason they matter. A raindrop or snowflake falls through a layer of air above freezing, melts entirely or largely, then falls through a layer below freezing near the ground and refreezes before landing. If the cold layer near the ground is too shallow to refreeze the drops, they land as liquid and freeze on contact: that is freezing rain.

WMO-No. 782 states that ice pellets can indicate that freezing rain may be present at higher levels, with the danger of severe icing after take-off or during descent and landing. CAP 746 says that ice pellets indicate that supercooled precipitation may be present at higher levels and may occur before or after freezing rain. A report of PL is therefore a clue about the vertical structure of the air, not only about the ground. Freezing rain and drizzle are covered on the FZ freezing page.

Intensity of ice pellets

FMH-1 sets PL intensity in two ways. When the rate of fall can be measured, it uses Table 8-1, shared with rain: light up to 0.10 inch per hour, moderate 0.11 to 0.30 inch, heavy more than 0.30 inch. When it cannot, Table 8-3 gives a visual guide, repeated in the FAA AIM (section 7-1-16):

Intensity Criteria
Light Scattered pellets that do not completely cover an exposed surface, regardless of duration; visibility not affected
Moderate Slow accumulation on the ground; visibility reduced by ice pellets to less than 7 statute miles
Heavy Rapid accumulation on the ground; visibility reduced by ice pellets to less than 3 statute miles

The general rules for signs are on the intensity and vicinity page.

Showers and thunderstorms with PL

The sources disagree on SH. FMH-1 lists ice pellets among the types that may be combined with SH, and NWS Instruction 10-813 shows SHPL in its TAF matrix and gives the example SHSNPL, moderate snow showers and ice pellets. WMO-No. 782 states plainly that the descriptor SH cannot be associated with ice pellets. A METAR from outside the US should therefore not contain SHPL; a US report may. The SH showers page explains the descriptor.

FMH-1 also allows TS with PL, and NWS Instruction 10-813 lists TSPL. CAP 746 lists TS only with rain, snow, small hail or snow pellets, and hail.

PL in mixed groups

Ice pellets often come with other precipitation during a transition between rain and snow. NWS Instruction 10-813 gives FZRASNPL: moderate freezing rain, snow and ice pellets, with freezing rain first because of the descriptor and the other types in order of dominance. The FAA AIM gives +SHRASNPL, heavy rain showers with snow and ice pellets. Snow mixtures are discussed on the SN snow page.

A schematic US report shows a winter mix:

METAR KXYZ 220853Z 05012KT 3SM -FZRAPL BR OVC008 M01/M02 A2998

It reads: wind from 050 degrees at 12 knots, visibility 3 statute miles, light freezing rain and ice pellets with freezing rain dominant, mist, overcast at 800 feet, temperature minus 1 °C.

Special reports and automated stations

PL changes trigger reports in the US. FMH-1 and the FAA AIM list the start, end or change in intensity of ice pellets among the criteria for a SPECI. NWS Instruction 10-813 also lists the start or end of ice pellets among the events that call for a TAF amendment.

Ice pellets are not reported by every automated station. The FAA AIM lists ice pellets among the elements added by observers at Service Level B, which means a fully automated report can miss them. FMH-1 codes precipitation that an automated station cannot identify as UP, unknown precipitation.

Ice crystals: diamond dust

FMH-1 defines ice crystals, or diamond dust, as a fall of unbranched ice crystals in the form of needles, columns or plates, and points out the difference from snow crystals, which are branched. The FAA AIM lists IC as ice crystals (diamond dust).

IC is the only frozen precipitation with no intensity at all. FMH-1 states that intensity is coded with all precipitation types except ice crystals, hail and unknown precipitation, and NWS Instruction 10-813 adds that no intensity is ever given to hail, snow pellets or ice crystals. A METAR can therefore contain IC, but never -IC or +IC.

IC appears in the FMH-1 code table, the NWS TAF matrix and the FAA AIM list. It was not found in the text extraction of WMO-No. 782 or CAP 746 used for this page. The comparison with snow grains is on the SG snow grains page.

PL and IC as recent weather

WMO-No. 782 lists moderate or heavy ice pellets among the phenomena that can be reported as recent weather, which gives REPL. No recent weather form for IC was found in the sources consulted. The RE group is explained on the recent weather page.

In real reports

The "In real reports" box on this page shows the share of METARs in the NOAA Aviation Weather Center sample collected for this site that contain PL and IC. Both depend heavily on the season and the region, so a sample collected over a short period in late autumn may contain few or none.

Method and limits

Definitions and rules are taken from FMH-1 (2019, chapter 8 definitions, Tables 8-1 and 8-3, coding rules and SPECI criteria), WMO-No. 782 (2025 edition), CAP 746 (section 4.84), NWS Instruction 10-813 (October 2024, Appendix B) and the FAA AIM, chapter 7, section 1. The sources disagree on SHPL and TSPL, which FMH-1 and NWS allow and WMO-No. 782 or CAP 746 do not; the page states both. The labels of FMH-1 Table 8-1 are misaligned in the text extraction of the PDF used here; the thresholds match the rain table and the FAA AIM. The explanation of how ice pellets form summarises the WMO-No. 782 and CAP 746 statements and the FMH-1 definition. The KXYZ line is a schematic example, not a real report. The box counts PL and IC in the text of the METARs; mixed groups may be included depending on how the statistic keys count them.

Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).

Frequently asked questions

What does PL mean in a METAR?

PL means ice pellets: hard grains of ice, transparent or translucent, round or irregular, with a diameter of 5 mm or less. They are frozen raindrops or largely melted snowflakes that have refrozen. -PL is light, PL moderate and +PL heavy.

Why do ice pellets matter for pilots?

WMO-No. 782 states that ice pellets can indicate freezing rain at higher levels, with the danger of severe icing after take-off or during descent and landing. CAP 746 adds that they may occur before or after freezing rain.

What does IC mean in a METAR?

IC means ice crystals, also called diamond dust. FMH-1 defines them as a fall of unbranched ice crystals in the form of needles, columns or plates. Snow crystals, by contrast, are branched. IC is coded without any intensity sign.

Can ice pellets be reported as showers?

It depends on the rules. FMH-1 allows SH with ice pellets, and NWS Instruction 10-813 lists SHPL. WMO-No. 782 states that the SH descriptor cannot be associated with ice pellets, so SHPL is not valid under the WMO rules.

How is the intensity of ice pellets estimated?

FMH-1 uses the rate of fall of Table 8-1 when it can be measured. By eye, Table 8-3 gives light for scattered pellets that do not cover a surface, moderate for slow accumulation with visibility below 7 statute miles, heavy for rapid accumulation below 3 miles.

Sources

  1. World Meteorological Organization (2025). Aerodrome Reports and Forecasts: A Users' Handbook to the Codes (WMO-No. 782), 2025 edition
  2. UK Civil Aviation Authority (2023). CAP 746, Requirements for Meteorological Observations at Aerodromes
  3. Office of the Federal Coordinator for Meteorology (2019). Federal Meteorological Handbook No. 1, Surface Weather Observations and Reports (FCM-H1-2019)
  4. National Weather Service (2024). NWS Instruction 10-813, Terminal Aerodrome Forecasts (October 30, 2024), Appendix B
  5. Federal Aviation Administration. Aeronautical Information Manual, chapter 7, section 1