PROB30 and PROB40 in a TAF: probability groups explained

Tafrob editorial team · Updated · 6 min read

Short answer

PROB30 and PROB40 give a 30 or 40 percent chance that the following conditions occur during a stated period. ICAO and EU rules allow only these two values, alone or as PROB TEMPO. Below 30 percent nothing is forecast, and from 50 percent the forecaster uses BECMG, TEMPO or FM instead. The NWS uses PROB30 only.

Key points

  • Only two values exist: PROB30 and PROB40. Under 30 percent is not mentioned in a TAF.
  • At 50 percent or more, WMO and Transport Canada say BECMG, TEMPO or FM is used instead.
  • PROB30 TEMPO and PROB40 TEMPO express a chance of temporary fluctuations, a form the NWS does not use.
  • NWS TAFs use PROB30 only, for thunderstorms or precipitation, for 6 hours or less.
  • PROB is not allowed in the TREND forecast appended to a METAR.
Four cumulonimbus clouds with anvil shaped tops spread along the horizon
Photo: Peter Broster, CC0, via Wikimedia Commons

What a PROB group says

A PROB group puts a number on uncertainty. It is written as PROB followed by two digits, then a time period, then the conditions that may occur. WMO-No. 782 explains when it is used: the forecaster is not confident enough to write the change as a firm forecast, but the element is significant enough for operations that it should be mentioned. The two digits are the probability in percent, and only 30 or 40 are used.

The group never replaces the prevailing forecast. It describes an alternative that may or may not happen. If the event does not happen, the main line of the TAF, or the last FM or BECMG before the PROB, stays in force for the whole period. The pillar page on reading a TAF shows where the group sits in a full forecast.

A simple example from WMO-No. 782:

TAF LUDO 132030Z 1322/1407 27003KT 4000 SCT008
      BECMG 1403/1405 1500 BR BKN004
      PROB30 1405/1407 0800 FG

Between 0500 and 0700 UTC on the 14th there is a 30 percent chance of fog with visibility of 800 metres. The other 70 percent of the time, the forecast after the BECMG group holds: 1,500 metres in mist under a broken layer at 400 feet.

Why only 30 and 40, and no PROB50

The two values come from a pair of thresholds stated in the same terms by WMO-No. 782 and the Transport Canada AIM.

Probability What the forecaster writes
Under 30 percent Nothing. WMO-No. 782 calls it not significant enough to mention.
30 percent PROB30
40 percent PROB40
50 percent or more BECMG, TEMPO or FM. The change is forecast outright.

This answers the frequent question about PROB50 or PROB60. None of the sources cited here sets out a separate rule forbidding them. They do not exist because, at 50 percent or more, the event counts as more likely than not, and the code already has groups for that: BECMG for a gradual change, TEMPO for short fluctuations, and FM for a clean break. NWS Instruction 10-813 defines TEMPO with a probability above 50 percent, which closes the range from the other side.

PROB alone and PROB TEMPO

Regulation (EU) 2017/373 describes two uses. A PROB group with only a time period gives the probability of alternative conditions during that period. A PROB group followed by TEMPO gives the probability of temporary fluctuations. The EU template lists the change indicators as PROB30 [TEMPO] or PROB40 [TEMPO] or BECMG or TEMPO or FM, and gives these code shapes:

PROB30 1412/1414 0800 FG
PROB40 TEMPO 2923/3001 0500 FG

The first means a 30 percent chance of fog from 1200 to 1400 UTC on the 14th. The second means a 40 percent chance that fog with 500 metres visibility will come and go between 2300 UTC on the 29th and 0100 UTC on the 30th. The TEMPO limits still apply inside the window, so each spell of fog would last under 1 hour. See the TEMPO page for those limits.

WMO-No. 782 shows the combined form in a full TAF:

TAF LUDO 130530Z 1307/1316 27015KT 9999 SCT015
      TEMPO 1311/1316 4000 +SHRA BKN010CB
      PROB30 TEMPO 1314/1316 TSRA

Showers are forecast to come and go from 1100 UTC. Within the last two hours, there is in addition a 30 percent chance of thunderstorms during those fluctuations. The same handbook warns that TEMPO and PROB30 must not be confused: TEMPO means the forecaster is confident the fluctuations will happen, while PROB30 means only a moderate chance.

The Met Office GetMet leaflet prints a UK TAF that uses the same combination, PROB30 TEMPO 1108/1116 17025G40KT 4000 TSRA BKN012CB, and states that only 30 percent or 40 percent probability is used.

How the NWS uses PROB30

NWS Instruction 10-813 is stricter than the ICAO and EU frame:

  • PROB30 is the only PROB group used. It is meant for a 30 percent chance of a thunderstorm or precipitation event, together with the wind, visibility and sky conditions that go with it.
  • A PROB30 group covers 6 hours or less.
  • Only one PROB30 group is used in any subsequent FM group, and it is written on the same line as the prevailing conditions.
  • PROB30 carries no vicinity (VC) weather and no non convective low level wind shear.
  • PROB30 is not a direct modifier of TEMPO, and TEMPO is not a modifier of PROB30. The PROB TEMPO form is not used.

Two examples from the instruction show the style. KSEA has PROB30 0915/0919 1SM +TSRA BR OVC007CB after a prevailing line with 6 miles or more visibility, a 30 percent chance of heavy thunderstorms with rain between 1500 and 1900 UTC. KROW has PROB30 0304/0306 27020G45KT 1SM TSRA OVC012CB, which adds a gusty wind to the thunderstorm. The instruction also says that when confidence is too low for VC weather, PROB30 is the group to use.

There is one point of divergence between FAA and NWS texts. The Aviation Weather Handbook (2024) still states that the NWS does not use PROB30 in the first 9 hours of a TAF. The October 2024 revision of NWS Instruction 10-813 lists in its change log the removal of the 9 hour PROB30 constraint. The NWS instruction is the newer document and the one that governs NWS forecasters, so a PROB30 can now appear early in a US TAF.

The handbook adds that US military and international TAFs may also use PROB40 and do not share the NWS restrictions.

The Canadian rules

Transport Canada restricts PROB to aviation hazards: thunderstorms, freezing precipitation, low level wind shear at or below 1,500 feet AGL, and ceiling and visibility values that matter to operations, such as alternate or approach limits. The period is in whole UTC hours, so PROB30 2817/2821 means a 30 percent chance between 1700 and 2100 UTC on the 28th.

Canada allows PROB with TEMPO and with BECMG, with three limits. A PROB must fall entirely within or entirely outside the TEMPO hours and is written after the TEMPO. TEMPO, PROB and BECMG may not all be combined. A PROB may be followed by a BECMG, but the two may not share hours.

How PROB is used in planning

NWS Instruction 10-813 notes that the lowest condition in a TAF, including any PROB or TEMPO, drives user decisions, and asks forecasters to use PROB30 and TEMPO sparingly for short changes. How a PROB group counts for alternate minima depends on the operator's rules, not on the code itself. The flight planning page covers that question, and the thunderstorm page covers the most common use of PROB30.

Common misreadings

  • Reading PROB40 as more serious than TEMPO. A TEMPO is a firm forecast of fluctuations. PROB40 is a 40 percent chance.
  • Expecting PROB50 or higher. The code stops at 40, and the next step up is a change group.
  • Reading the conditions after PROB as the only weather in the window. They are an alternative to the prevailing forecast, which still applies if the event does not occur.
  • Looking for PROB in a METAR TREND. Regulation (EU) 2017/373 states that PROB shall not be used in TREND forecasts, as noted on the TREND and NOSIG page.
  • Applying NWS limits to an international TAF. PROB40 and PROB30 TEMPO are normal outside the NWS.

The TAF decoder splits a PROB line into its period and conditions.

Method and limits

The rules here come from NWS Instruction 10-813 (October 2024), WMO-No. 782 (2025 edition), Regulation (EU) 2017/373, the Transport Canada AIM MET section, the Aviation Weather Handbook and the Met Office GetMet leaflet. The code lines are quoted from those documents, with line breaks added for reading in the WMO examples. None of these sources gives an explicit reason why PROB50 does not exist. The explanation above relies on the threshold statements in WMO-No. 782 and the Transport Canada AIM, which say a change group is used from 50 percent. The 9 hour conflict is reported as found in the two documents.

Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).

Frequently asked questions

What does PROB30 mean in a TAF?

PROB30 means there is a 30 percent probability that the conditions written after it occur during the stated period. The period follows the group as DDHH/DDHH in whole hours. Outside that window, and if the event does not happen, the prevailing forecast applies.

Why is there no PROB50 or PROB60?

WMO-No. 782 and the Transport Canada AIM both state that when the probability reaches 50 percent or more, the forecaster uses BECMG, TEMPO or FM instead. A probability that high is treated as a forecast in its own right, so a probability group is not needed. Under 30 percent, the event is not mentioned at all.

What is the difference between PROB30 and PROB30 TEMPO?

PROB30 alone gives a 30 percent chance of alternative conditions for the whole stated period. PROB30 TEMPO gives a 30 percent chance of temporary fluctuations within that period. Regulation (EU) 2017/373 describes both forms. NWS Instruction 10-813 does not use the combined form.

Do US TAFs use PROB40?

NWS civil TAFs do not. NWS Instruction 10-813 says PROB30 is the only PROB group used. The Aviation Weather Handbook adds that US military and international TAFs may use PROB40 as well, so a TAF for a military field in the United States can carry it.

Can a PROB group appear in a METAR TREND?

No. Regulation (EU) 2017/373 states that PROB shall not be used in TREND forecasts. The landing forecast attached to a METAR uses only BECMG, TEMPO and NOSIG.

Sources

  1. National Weather Service (2024). NWS Instruction 10-813, Terminal Aerodrome Forecasts (October 30, 2024)
  2. World Meteorological Organization (2025). Aerodrome Reports and Forecasts: A Users' Handbook to the Codes (WMO-No. 782), 2025 edition
  3. European Union (EUR-Lex) (2017). Commission Implementing Regulation (EU) 2017/373, Annex V (Part-MET), aerodrome forecasts and TAF template
  4. Transport Canada (2025). TC AIM, MET section 7.0 Aerodrome forecasts (TAFs)
  5. Federal Aviation Administration (2024). Aviation Weather Handbook (FAA-H-8083-28A), chapter 27
  6. Met Office (2024). GetMet: aerodrome forecast TAF decode