VOLMET: how in-flight weather broadcasts work
VOLMET is meteorological information for aircraft in flight. A voice VOLMET is a continuous, repeating broadcast of current METARs, sometimes with TAFs and SIGMETs, for a set of aerodromes. In the United Kingdom, four VHF channels each carry nine or ten stations, in English, around the clock, with the elements spoken in METAR order.
Key points
- VOLMET gives aircraft in flight current METAR and SPECI reports by continuous voice broadcast, usually on VHF.
- Scheduled VOLMET, normally on HF, can also carry TAF and SIGMET where regional agreement says so.
- D-VOLMET delivers similar information by data link, including SIGMET and, where available, AIRMET.
- The four UK VHF VOLMET channels run H24 in English and broadcast half-hourly reports in METAR order.
- Non-essential words such as wind and visibility are not spoken.
- The VHF broadcast is not meant for ground use: a typical channel has a range of about 300 NM at FL300.

What VOLMET is
The WMO Technical Regulations (WMO-No. 49, Volume II) define VOLMET as meteorological information for aircraft in flight. It comes in two forms:
- a VOLMET broadcast: current METAR, SPECI, TAF and SIGMET, as appropriate, by continuous and repetitive voice broadcasts;
- D-VOLMET: the same kind of information by data link, including special air-reports not covered by a SIGMET and, where available, AIRMET.
The aerodromes, the order in which they are read and the broadcast times are set by regional air navigation agreement. A pilot can therefore get the weather at a destination and its alternates without calling anyone, while an ATIS gives the same kind of information for one airport only.
Continuous and scheduled broadcasts
The Technical Regulations set different contents for the two broadcast types:
| Type | Normal band | Contents |
|---|---|---|
| Continuous | VHF | Current METAR and SPECI, with trend forecasts where available |
| Scheduled | HF | Current METAR and SPECI, with trend forecasts where available, and TAF and SIGMET where regional air navigation agreement says so |
The same text states that a broadcast should use standard radiotelephony phraseologies, and that a SIGMET, where it is included in a scheduled broadcast, is sent at the start of the broadcast or of a five-minute block. If a report has not arrived in time, the latest available report is included together with its observation time. The SIGMET page explains what that message is.
The UK VHF channels
The UK AIP (GEN 3.5, Table 3.5.7.1) lists four VHF broadcasts. All operate H24, continuously, in English.
| Broadcast | Frequency | Stations |
|---|---|---|
| London VOLMET (Main) | 135.375 MHz | Amsterdam, Brussels, Dublin, Glasgow, London Gatwick, London Heathrow, London Stansted, Manchester, Paris/Charles de Gaulle |
| London VOLMET (South) | 128.600 MHz | Birmingham, Bournemouth, Bristol, Cardiff, Jersey, London Luton, Norwich, Southampton, Southend, Exeter |
| London VOLMET (North) | 126.600 MHz | East Midlands, Humberside, Isle of Man, Leeds Bradford, Liverpool, London Gatwick, Manchester, Newcastle, Teesside International |
| Scottish VOLMET | 125.725 MHz | Aberdeen/Dyce, Belfast Aldergrove, Edinburgh, Glasgow, Inverness, London Heathrow, Prestwick, Stornoway, Sumburgh |
The AIP notes that the range of the North broadcast is extended to cover southeast England and the English Channel. CAP 746 states that each channel carries a different METAR set and describes VOLMET as a VHF broadcast of reports for a maximum of nine aerodromes on each channel in a continuous loop, with a range of around 300 nautical miles at FL300. The South list above has ten names, which differs from that statement.
The order of the elements
For these broadcasts the reports are half-hourly METARs. The AIP gives the order in which the elements are spoken: surface wind, visibility or CAVOK, RVR if applicable, weather, cloud, temperature, dew point, QNH, recent weather if applicable, wind shear if applicable and TREND if applicable. Non-essential words such as "surface wind" and "visibility" are not spoken. The terms are those of a METAR: the CAVOK page covers the replacement of visibility, weather and cloud, and the trend page covers the final element.
A spoken report
The AIP does not print a sample of a VOLMET broadcast. A schematic version following its order of elements looks like this, with an invented aerodrome:
Exampleton: 240 degrees 12 knots, 9999, few 3000 feet, 14, 08, QNH 1016, NOSIG
It reads: wind from 240 degrees at 12 knots, visibility 10 km or more, a few clouds at 3,000 feet, temperature 14 C, dew point 8 C, QNH 1016 hPa, no significant change expected. The exact phraseology depends on the broadcast. The line is a schematic example, not a recording.
Reading the schematic line, element by element
| Spoken element | Reading |
|---|---|
| Exampleton | The aerodrome, named at the start of its report |
| 240 degrees 12 knots | Surface wind, as in the wind group |
| 9999 | Visibility of 10 km or more, replaced by CAVOK when its conditions are met |
| few 3000 feet | Cloud: amount and height of base |
| 14, 08 | Temperature and dew point, in degrees Celsius |
| QNH 1016 | Altimeter setting in hectopascals |
| NOSIG | Trend: no significant change expected |
RVR, weather, recent weather and wind shear would appear in their place in the order given above only when they apply to the report, which is why the line above is short. A real report for a busy airport can therefore be longer than the schematic one, and a pilot should expect the extra groups to follow the same order each time.
VOLMET and ATIS compared
The two services answer different questions. An ATIS serves a single airport and carries operational items such as the runway in use. A VOLMET serves several aerodromes in a loop and carries the weather report only. The WMO text sets out that a scheduled broadcast can also carry a TAF and a SIGMET where regional agreement says so, which an ATIS does not. Because the report is read in METAR order, a pilot who knows the METAR format can follow it by ear and note only the stations that matter for the flight.
Outside the United Kingdom
The AIP notes that an HF VOLMET for North Atlantic flights, Shannon VOLMET, is operated by the Republic of Ireland. No frequencies or schedules for it are given on this page, because they were not verified. In the United States, the sources read for this page do not describe a VOLMET service, and the equivalents are ATIS and pilot services described elsewhere on this site, such as the PIREP page.
Method and limits
The definitions and the content of continuous and scheduled broadcasts come from WMO-No. 49, Volume II (2018 edition updated in 2021). WMO describes the first two parts of that volume as discontinued at the end of 2023, with ICAO Annex 3 as the reference, and the Annex text itself was not read for this page, so the wording should be checked against the current Annex 3. The UK frequencies, stations, hours and element order come from the UK AIP GEN 3.5 (AIRAC of January 22, 2026), and the range statement from CAP 746 (2023). Shannon VOLMET frequencies, the technical detail of D-VOLMET and any phase-out plan were not verified. The picture shows a communications receiver and is not tied to a broadcast.
Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).
Frequently asked questions
What does VOLMET stand for?
The sources read for this page define VOLMET as meteorological information for aircraft in flight and do not expand the name. The WMO Technical Regulations define a VOLMET broadcast as the provision of current METAR, SPECI, TAF and SIGMET by continuous and repetitive voice broadcasts.
Which UK VOLMET frequencies exist?
The UK AIP lists London VOLMET Main on 135.375 MHz, South on 128.600 MHz, North on 126.600 MHz and Scottish VOLMET on 125.725 MHz. All run continuously, 24 hours a day, in English, with half-hourly reports.
In which order are the weather elements read?
The UK AIP gives the order as surface wind, visibility or CAVOK, RVR if applicable, weather, cloud, temperature, dew point, QNH, recent weather, wind shear and TREND, each if applicable. Words such as surface wind and visibility are left out.
What is the difference between VOLMET and D-VOLMET?
VOLMET is a voice broadcast. D-VOLMET provides the same kind of information by data link. The WMO Technical Regulations say D-VOLMET carries METAR, SPECI, TAF and SIGMET, special air-reports not covered by a SIGMET and, where available, AIRMET.
Can I receive VOLMET on the ground?
VHF broadcasts are designed for aircraft at altitude. CAP 746 describes a range of around 300 nautical miles at FL300, and UK pilot guidance says reception abroad is not normally possible. Reception at low level or on the ground is much shorter.
Sources
- NATS, United Kingdom (2026). United Kingdom AIP, GEN 3.5 Meteorological Services
- UK Civil Aviation Authority (2023). CAP 746, Requirements for Meteorological Observations at Aerodromes
- World Meteorological Organization (2021). Technical Regulations, Volume II: Meteorological Service for International Air Navigation (WMO-No. 49), 2018 edition updated 2021