What is a ceiling? The lowest broken or overcast layer
A ceiling is the height above the ground of the lowest cloud layer reported as broken or overcast, or of the vertical visibility into an obscuration. In a METAR it is read from the first BKN, OVC or VV group: BKN008 OVC020 gives a ceiling of 800 feet. FEW and SCT layers never form a ceiling, however low they are.
Key points
- The ceiling is the lowest layer reported as BKN or OVC, or the vertical visibility (VV).
- FEW and SCT layers never count as a ceiling, even at 200 feet.
- ICAO and EU SERA limit the definition to cloud below 20,000 feet covering more than half the sky.
- The height is above the ground or water, so it is above the aerodrome in a METAR.
- US summation can turn an upper layer into a ceiling when the layers below add up to BKN.
- Ceilings drive flight rules, alternate planning and the US flight categories.

The layer that decides
A METAR can list several cloud layers, but one of them matters more than the others for planning: the ceiling. It is not written as a separate group. The reader finds it by scanning the cloud groups from the lowest and stopping at the first one coded BKN or OVC, or at a vertical visibility.
| Code | Meaning |
|---|---|
FEW005 SCT012 BKN030 |
Ceiling 3,000 feet: the first BKN layer |
BKN008 OVC020 |
Ceiling 800 feet |
SCT004 |
No ceiling: scattered cloud only |
VV002 |
Ceiling 200 feet: vertical visibility |
CAVOK |
No ceiling reported |
The definitions
The FAA AIM (section 7-1-14) defines the ceiling as the "height above ground (or water) level of the lowest layer of clouds or obscuring phenomenon that is reported as "broken," "overcast," or "obscuration"". FMH-1 gives the same rule for US observations: the ceiling is the lowest layer reported as BKN or OVC, or the vertical visibility into an indefinite ceiling.
The ICAO definition, in Annex 2, is repeated word for word in the EU Standardised European Rules of the Air (SERA, Regulation (EU) No 923/2012): "the height above the ground or water of the base of the lowest layer of cloud below 6 000 m (20 000 ft) covering more than half the sky". Covering more than half the sky means more than 4 oktas, so BKN or OVC. The 20,000 foot limit has little practical effect in a METAR, where most reported layers are far lower.
US Air Force guidance (AFMAN 15-124) uses the same rule and adds that the layers are treated as opaque. Transport Canada takes the lower of two values: the lowest layer covering more than half the sky, or the vertical visibility.
FEW and SCT never count
The rule has a sharp edge. A layer of 4 oktas at 300 feet is SCT and does not form a ceiling; a layer of 5 oktas at 3,000 feet is BKN and does. A METAR with SCT003 SCT015 has no ceiling at all, even though a pilot on approach will fly through cloud. The okta ranges behind the codes are explained on the cloud cover codes page.
That is why the ceiling alone never describes the sky. A low scattered layer can still hide the runway for part of an approach, and the visibility group, explained on the visibility page, says how far the pilot can see horizontally.
Summation in US reports
FMH-1 reports each layer with the total cover at and below its height. Two layers of 3 oktas each, at 1,500 and 4,000 feet, are therefore reported as SCT015 BKN040: the upper layer reaches 6 oktas once the lower one is added. The ceiling is 4,000 feet, even though neither layer covers more than half the sky alone.
Under WMO-No. 782 and CAP 746, each layer is reported with its own amount, so the same sky could appear as SCT015 SCT040 with no ceiling. The difference between rule sets is small in most weather, but it explains why two reports of a similar sky can disagree on the ceiling.
Vertical visibility as a ceiling
When fog, snow or another obscuration hides the sky, the observer cannot see a cloud base. The cloud group is replaced by VV and the height to which the observer can see upward, as in VV003. FMH-1 and the FAA AIM both treat this as a ceiling. The AIM gives the reading of 1/8 SM FG VV006: visibility one eighth of a statute mile in fog, indefinite ceiling six hundred. The code is explained on the vertical visibility page.
Height above what
The ceiling is a height, not an altitude. In a METAR and a TAF it is measured above the aerodrome. The FAA AIM notes that pilot reports give cloud heights above mean sea level instead, so a PIREP and a METAR for the same layer can show different numbers. The coding steps, 100 feet at low levels, are explained on the cloud height page.
FMH-1 also allows a remark when the ceiling changes quickly. CIG 005V010 means a variable ceiling between 500 and 1,000 feet, and CIG 002 RWY11 gives a ceiling measured at a second sensor, at a different location. Such remarks follow RMK, as explained on the remarks page.
Thresholds in flight rules
Several rules depend directly on the ceiling. SERA uses the ceiling in its definitions of instrument and visual meteorological conditions. A VFR flight may not enter or take off from a control zone when the ceiling is less than 450 m (1,500 ft), unless cleared under special VFR, and special VFR itself requires a ceiling of at least 180 m (600 ft).
In the United States, 14 CFR 91.169 sets the weather needed to list an airport as an IFR alternate when there is no published standard: for aeroplanes, a ceiling of at least 2,000 feet and a visibility of at least 3 statute miles from one hour before to one hour after the estimated time of arrival. 14 CFR 91.167 uses the same figures for the destination when deciding whether an alternate is needed at all.
The US flight categories, VFR, MVFR, IFR and LIFR, are also built on the ceiling and the visibility; they are explained on the flight categories page.
Ceilings in a TAF
A TAF uses the same cloud groups, so the ceiling is read the same way. WMO-No. 782 lists ceiling changes among the reasons for a change group: the lowest BKN or OVC layer reaching or passing 100, 200, 500, 1,000 or 1,500 feet, and a layer below 1,500 feet changing between NSC, FEW or SCT and BKN or OVC. A TEMPO or BECMG group can therefore bring a ceiling in or take it away. When CAVOK is forecast, there is no cloud below 5,000 feet and no ceiling to read, as explained on the CAVOK page.
A schematic report
METAR LXXX 190650Z 18006KT 3500 BR FEW004 SCT009 BKN014 OVC030 09/08 Q1021
It reads: wind from 180 degrees at 6 knots, visibility 3,500 m in mist, few clouds at 400 feet, scattered at 900 feet, broken at 1,400 feet, overcast at 3,000 feet. The ceiling is 1,400 feet, the first BKN layer. The two lower layers are below it but do not count, which is one reason to read the whole cloud group rather than the ceiling alone.
In real reports
The "In real reports" box on this page has no single code to count: a ceiling is not a group of its own. The boxes on the cloud cover and vertical visibility pages show how often BKN, OVC and VV appear in the NOAA Aviation Weather Center sample collected for this site.
Method and limits
Definitions are taken from the FAA AIM (section 7-1-14 and the METAR examples in chapter 7, section 1), EU Regulation 923/2012 (SERA, the ceiling definition and the VFR and special VFR rules), FMH-1 (2019, sky condition and remarks), WMO-No. 782 (2025 edition, cloud group and TAF change criteria) and CAP 746. The US Air Force and Transport Canada wordings come from AFMAN 15-124 and the TC AIM, MET 8.2. The alternate figures come from 14 CFR 91.167 and 91.169 and apply to aeroplanes. The summation example is an illustration of the FMH-1 rule, not a quoted example. The LXXX line is a schematic example, not a real report. The image shows an airliner in low stratus; it is not linked to a specific report. The page has no statistics box because the ceiling is derived from other groups rather than counted as a code.
Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).
Frequently asked questions
What is the ceiling in a METAR?
It is the height of the lowest layer reported as BKN or OVC, or the vertical visibility when the sky is hidden. In FEW005 SCT012 BKN030 the ceiling is 3,000 feet: the two lower layers are too thin to count, however low they are.
Does a scattered layer count as a ceiling?
No. A ceiling needs more than half the sky covered, which means BKN (5 to 7 oktas) or OVC (8 oktas). FEW and SCT cover 4 oktas or less, so a sky with SCT003 and nothing else has no ceiling, even though the cloud is very low.
Is vertical visibility a ceiling?
Yes. The FAA AIM includes obscuring phenomena reported as an obscuration, and FMH-1 counts the vertical visibility as the ceiling. The AIM reads 1/8 SM FG VV006 as an indefinite ceiling of six hundred feet.
What is the ICAO definition of a ceiling?
ICAO Annex 2 and the EU SERA regulation define the ceiling as the height above the ground or water of the base of the lowest layer of cloud below 6,000 m (20,000 ft) covering more than half the sky.
Why does the ceiling matter to pilots?
Flight rules use it. EU SERA uses 1,500 feet for VFR in a control zone and 600 feet for special VFR, and the US alternate rule in 14 CFR 91.169 uses a ceiling of 2,000 feet with 3 statute miles around the arrival time.
Sources
- Federal Aviation Administration. Aeronautical Information Manual, chapter 7, section 1
- European Union, EUR-Lex (2012). Commission Implementing Regulation (EU) No 923/2012 (SERA)
- Office of the Federal Coordinator for Meteorology (2019). Federal Meteorological Handbook No. 1, Surface Weather Observations and Reports (FCM-H1-2019)
- World Meteorological Organization (2025). Aerodrome Reports and Forecasts: A Users' Handbook to the Codes (WMO-No. 782), 2025 edition
- UK Civil Aviation Authority (2023). CAP 746, Requirements for Meteorological Observations at Aerodromes