US vs ICAO METAR differences: a full comparison table
US and ICAO METARs share one code, but national practice differs. The US averages wind over 2 minutes, ICAO over 10. The US reports visibility in statute miles, ICAO in meters. The US altimeter group starts with A in inches of mercury, ICAO with Q in hectopascals. CAVOK, TREND and NOSIG belong to the ICAO format only.
Key points
- Wind: the US averages over 2 minutes, ICAO over 10 minutes, so the same weather can give slightly different wind groups.
- Visibility: US reports use statute miles and the SM suffix, ICAO reports use four digits in meters.
- Pressure: A followed by four digits is inches of mercury in hundredths, Q followed by four digits is hectopascals.
- RVR: the US writes feet with an FT suffix, ICAO writes meters and may add a trend letter.
- CAVOK, TREND and NOSIG are ICAO elements. The FMH-1 METAR code format has none of them.

Same code, different national practice
A METAR from a US airport and one from a European airport look alike, because they come from the same family of WMO codes. FMH-1, the US observing handbook, says its METAR and SPECI coding conforms to the WMO forms, with "United States exceptions" filed with the WMO. Those exceptions reflect national practices that differ from the WMO manual. This page lists the differences confirmed in the primary documents: FMH-1 for the US, and WMO-No. 782 and WMO-No. 49 Volume II for the ICAO and WMO side.
If you only need the group order, read how to read a METAR first. Here the focus is on what changes from one system to the other.
Comparison table
| Element | ICAO and WMO format | US format (FMH-1) |
|---|---|---|
| Wind averaging | 10-minute mean | 2-minute average for direction and speed |
| Wind units | KT or MPS | KT |
| Gust | Maximum speed exceeds the mean by 10 kt (5 m/s) or more in the 10 minutes | Variation of 10 kt or more between peaks and lulls in the most recent 10 minutes |
| Variable direction | Variation of 60 degrees or more but less than 180 degrees, with mean speed 3 kt or more | Variable when speed is 6 kt or less, or when the variation is 60 degrees or more with speed above 6 kt |
| Visibility | Meters, four digits, 9999 for 10 km or more | Statute miles and fractions, suffix SM, M1/4SM for less than a quarter mile |
| RVR | Meters, such as R24/P2000, with optional trend letter | Feet with FT suffix |
| Altimeter | Q and four digits, hectopascals, rounded down | A and four digits, hundredths of inches of mercury |
| Cloud heights | 100 ft steps up to 10,000 ft, then 1,000 ft steps | Hundreds of feet |
| No-cloud codes | NSC, NCD in the ICAO format | SKC or CLR |
| CAVOK | Defined | Not in the METAR code format |
| TREND, NOSIG | Optional landing forecast appended | Not in the METAR code format |
| Remarks | Few, national use | A full RMK section with US-specific remarks |
The sections below give the source and a short explanation for each row.
Wind
FMH-1 defines wind direction and speed in a US METAR as 2-minute averages. WMO-No. 782 gives the ICAO value as a 10-minute mean. A shorter window follows changes faster, so a wind that is turning or building can show up in a US report before it shows up in an ICAO one. The wind group page explains the coding itself.
Gusts and variable direction
The two systems define a gust differently. In the ICAO format a gust is reported when the maximum speed exceeds the mean by 10 kt (5 m/s) or more in the 10 minutes. FMH-1 reports a gust when the variation between peaks and lulls in the most recent 10 minutes is 10 kt or more.
For direction, WMO-No. 782 describes the variable-direction group for a variation of 60 degrees or more but less than 180 degrees, with a mean speed of 3 kt or more, over the 10 minutes. FMH-1 treats the wind as variable when the speed is 6 kt or less, or when the direction varies by 60 degrees or more with a speed above 6 kt, in the 2-minute window.
Units
ICAO reports may give wind in knots (KT) or in meters per second (MPS). The US uses knots. Check the suffix before reading the number, and see units in METAR by country.
Visibility
ICAO reports give the prevailing visibility in meters as four digits, with 9999 for 10 km or more. US reports give it in statute miles with the SM suffix, and the letter M means "less than", so M1/4SM is less than one quarter of a mile. The reporting steps are different, so a conversion is only approximate. The full explanation is on the visibility page.
Runway visual range
WMO-No. 782 shows RVR in meters, for example R24/P2000, as a 10-minute mean, with an optional trend letter U, D or N. FMH-1 gives the code format as RDRDR/VRVRVRVRFT, so the value is in feet and the group ends in FT. Details are on the RVR page.
Altimeter setting: Q or A
ICAO reports start the pressure group with Q, followed by four digits in hectopascals, rounded down. US reports start with A, followed by four digits that are hundredths of inches of mercury. FMH-1 section 12.6.11 gives the US coding, and WMO-No. 782 notes that A is used by some countries that work in inches. The Aviation Weather Handbook explains why the units differ: the hectopascal was adopted by most countries after SI units were introduced in 1960, while the US still uses inches of mercury for altimetry.
Two examples of the format, written for this page to show the coding only:
Q0995
A2992
The first reads as 995 hectopascals. The second reads as 29.92 inches of mercury. See QNH and altimeter setting for how each is used.
Clouds
WMO-No. 782 defines the ICAO amounts as FEW for 1 to 2 oktas, SCT for 3 to 4, BKN for 5 to 7 and OVC for 8. Heights use 100 ft steps up to 10,000 ft and 1,000 ft steps above that. The ICAO format also has NSC and NCD for the case where no cloud is reported. FMH-1 uses SKC or CLR for a clear sky and gives heights in hundreds of feet. Manual US stations append CB, or TCU when there is no CB, to a layer containing them. FMH-1 defines the ceiling as the lowest layer reported as broken or overcast, or the vertical visibility into an indefinite ceiling.
NSC and NCD do not appear in the FMH-1 text, so this page does not assign those codes to the US system.
CAVOK, TREND and NOSIG
CAVOK replaces visibility, weather and cloud groups together when visibility is 10 km or more, there is no cloud of operational significance and no significant weather, as defined in WMO-No. 49 Volume II. A search of FMH-1 found no mention of CAVOK or TREND in the METAR code format. See the CAVOK page. WMO-No. 782 says a TREND may be appended to either a METAR or a SPECI under the ICAO format.
Remarks
The US METAR carries a remarks section after the body, introduced by RMK, with its own US-specific remarks. These add detail such as automated station type and sea-level pressure. The ICAO format has no equivalent section in the same sense.
Special reports
Both systems issue special reports between routine ones, but the criteria differ. See SPECI for the side-by-side list.
Practical advice for reading mixed reports
- Look at the pressure group first. A tells you inches of mercury, Q tells you hectopascals.
- Look at the visibility suffix. SM means statute miles, and four digits means meters.
- Look at the wind suffix for KT or MPS.
- Do not expect CAVOK or TREND in a US report, and do not expect an RMK section in an ICAO one.
This page is educational and is not a source for operational weather. National rules can differ from the WMO manual, so confirm local practice in the authority's own publications.
Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).
Frequently asked questions
Is a US METAR the same code as an ICAO METAR?
Mostly. FMH-1 says its coding conforms to the WMO METAR and SPECI forms, with United States exceptions filed with the WMO. Those exceptions reflect national practices that differ from the WMO manual, so the structure is shared but several groups differ.
Why do some METARs have Q and others A for pressure?
Q marks the altimeter setting in hectopascals, used under the ICAO format. A marks inches of mercury, used in the US. The Aviation Weather Handbook says most countries adopted the hectopascal after SI units came in, while the US still uses inches of mercury for altimetry.
Can I convert US visibility to ICAO visibility exactly?
Not exactly. The two systems report different steps. A statute mile is about 1,609 meters, so a converted value is an approximation, and each system rounds on its own scale. Compare the meaning, not the digits.
Does a US METAR ever contain CAVOK?
The METAR code format in FMH-1 does not include CAVOK. It is an ICAO element, defined for visibility, cloud and weather together. If a report from outside the US uses it, read it under the ICAO rules.
Sources
- Office of the Federal Coordinator for Meteorology (2019). Federal Meteorological Handbook No. 1 (FCM-H1-2019)
- World Meteorological Organization (2025). Aerodrome Reports and Forecasts, A Users' Handbook to the Codes (WMO-No. 782)
- World Meteorological Organization (2021). WMO-No. 49, Volume II, Meteorological Service for International Air Navigation (2018 edition, updated 2021)
- Federal Aviation Administration (2024). Aviation Weather Handbook (FAA-H-8083-28A)
- UK Civil Aviation Authority (2023). CAP 746, Requirements for Meteorological Observations at Aerodromes