ASOS and AWOS: how automated weather stations observe

Tafrob editorial team · Updated · 8 min read

Short answer

ASOS and AWOS are the two main automated observing systems in the United States. ASOS is a joint effort of the NWS, FAA and DOD and issues hourly and special reports. AWOS is similar but generally reports fewer elements, and comes in six types. Automated reports carry AUTO unless a certified human augments them.

Key points

  • The Aviation Weather Handbook names ASOS and AWOS as the two main kinds of automated observing system in the United States.
  • ASOS issues hourly METAR and SPECI reports, while AWOS generates a METAR every 20 minutes and does not report SPECI.
  • Sky condition is time averaged over 30 minutes and visibility over 10 minutes, so an automated report is not instant weather.
  • ASOS reports clouds up to 12,000 ft, so higher layers are missing unless a human observer adds them.
  • AUTO means no human input. An augmented report does not use AUTO.
Red and white lattice tower carrying weather sensors on an arm, with a gray equipment box at its base
Photo: Sgsfrangible, CC BY-SA 4.0, via Wikimedia Commons

Two systems, one purpose

Surface weather observations are the base of forecasts, warnings and flight planning. The Aviation Weather Handbook (FAA-H-8083-28A) describes three general types: manual, automated and augmented. Manual observations are made by a human observer certified by the FAA. They were the primary type before the mid-1990s, and the handbook says automated and augmented observations now make up the vast majority of surface observations in the United States.

An automated observation is derived from instruments and algorithms without human input or oversight. In the United States, two main kinds of system produce them: ASOS, the Automated Surface Observing System, and AWOS, the Automated Weather Observing System. The report carries the word AUTO unless a human weather observer augments it. The meaning of that flag, and of COR and NIL, is explained on the AUTO, COR and NIL page.

ASOS

The handbook states that ASOS is a joint effort of the National Weather Service, the FAA and the Department of Defense, and that it serves as the nation's primary surface weather observing network. It detects significant changes and disseminates hourly and special observations, so its output feeds both METAR and SPECI. The special report page lists what triggers a SPECI. One example in the handbook is a visibility falling below 3 miles.

ASOS also sends computer-generated voice observations by FAA ground-to-air radio to aircraft near the airport, and the same messages can be reached by telephone. The handbook adds that these broadcasts carry the one-minute observation (OMO), updated once a minute, which can differ from the METAR seen on the internet.

The elements ASOS reports, according to the handbook, are:

Element What is reported
Sky condition Height and amount of cloud, up to 12,000 ft
Visibility To at least 10 statute miles
Present weather Type and intensity for RA, SN, FZRA and UP, plus TS and VCTS
Obstructions to vision FG, BR and HZ
Pressure Sea level pressure and altimeter setting
Temperature Ambient temperature and dew point
Wind Direction, speed and character such as gusts and squalls
Precipitation Accumulation
Remarks Selected items such as variable cloud height or visibility, precipitation start and end, rapid pressure changes, wind shift and peak wind

The 1998 ASOS User's Guide, published by the NWS, says the system is built from sensors, a data collection package and, at airports with augmentation or backup support, an operator interface device. Its sensor list names a ceilometer (one to three sensors per site), a visibility sensor (one to three per site), a precipitation identification sensor, a freezing rain sensor, a lightning sensor at selected sites, pressure sensors, an ambient and dew point temperature sensor, an anemometer and a heated tipping bucket for precipitation accumulation. The same guide states that the field sensors are typically near the touchdown zone of the primary instrument runway. That guide dates from March 1998, when it counted about 500 commissioned systems, so equipment details and numbers may have changed since.

AWOS

The handbook calls AWOS a system similar to ASOS. It generally does not report all the elements ASOS reports, and it may not have the same level of backup sensors or maintenance response. It still gives pilots the weather information needed for 14 CFR part 91 operations. AWOS also broadcasts voice observations by radio and telephone, and it may be on airports, heliports, offshore platforms and drill ships.

Two rules differ from ASOS. AWOS generates a METAR at 20-minute intervals and does not report SPECI. And ownership varies: Federal AWOS units are owned, operated and maintained by the FAA, while non-Federal units belong to the site owner.

The handbook lists six AWOS types:

Type What it measures and reports
AWOS-A Altimeter only
AWOS-AV AWOS-A plus a visibility sensor
AWOS-1 Wind speed, direction and gusts, temperature, dew point, altimeter, density altitude
AWOS-2 AWOS-1 plus visibility
AWOS-3 AWOS-2 plus precipitation accumulation and cloud height
AWOS-3P, AWOS-3PT AWOS-3 with optional precipitation type and intensity (P) and thunderstorm or lightning (T) sensors
AWOS-4 All AWOS-3PT parameters plus freezing rain

Depending on the unit, the handbook also lists runway surface condition among the parameters that may be measured. A pilot reading an AWOS report should therefore expect that an element missing from the report may simply not be measured by that unit. The station type code in the remarks is covered on the AO1 and AO2 page.

How the sensors work

The ASOS guide describes the main sensing principles.

  • Cloud height comes from a laser beam ceilometer, a vertically pointed laser transmitter and receiver. As with radar, the time between the pulse and its reflection from a cloud base gives the height. The guide states a vertical measuring range of 12,600 ft and a reporting range of 12,000 ft. The ceilometer page gives more detail on the principle.
  • Visibility comes from a forward scatter sensor. A pulsed xenon flash lamp sends light twice a second, and the detector receives only the part scattered forward by the air in the sampling volume. The guide gives that volume as 0.75 cubic feet.
  • Precipitation accumulation comes from a heated tipping bucket with a 12-inch collector funnel. The guide notes known problems: a bucket can fall behind in very heavy rain, and heating to melt snow can cause evaporation in light freezing rain or snow.
  • Temperature and dew point come from a hygrothermometer that directly measures both and samples about six times per minute.

Time averaging

A human observer judges sky cover and visibility by looking around the horizon. The handbook says the automated station replaces that spatial averaging with time averaging of sensor data. In an automated observation, sky condition is an evaluation of sensor data gathered during the 30-minute period ending at the observation time. All other elements use data within 10 minutes or less. For visibility the handbook gives a 10-minute average.

The averaging algorithms are designed to report deteriorating conditions much more quickly than improving ones. The handbook gives an example: if dense fog was reported and suddenly dissipated, it might take up to 10 minutes for the one-minute observations to report VFR conditions. The ASOS guide adds that the system reports the onset of low stratus moving over the ceilometer within 2 minutes. A pilot who sees a different sky than the report describes may be looking at a change that has not yet passed through the averaging.

What automation cannot see

Several limits are stated in the sources read.

  1. Height. The top of what is reported is 12,000 ft, so layers above it do not appear. The ASOS guide gives an example where an observer augmented clouds above 12,000 ft and added remarks on cloud type and location that ASOS cannot provide.
  2. Position. The sensors sample one point. The guide says that if patches of fog or shallow fog form, or a fog bank moves over one end of the runway, ASOS may not see it if the sensor is not in the right location. Visibility from the visibility group therefore describes the air at the sensor, not the whole field.
  3. Scattered clouds. The guide says studies showed that up to 20 percent of FEW cloud events can be missed with a single ceilometer, typically widely scattered fair weather cumulus, which ASOS may report as CLR.
  4. Thin layers. Only opaque clouds are reported. Moisture layers considered too thin to be cloud are reported as a restriction to vertical visibility or not reported.
  5. Weather types. The handbook says basic present weather is limited to rain, snow, freezing rain and unknown precipitation, with thunderstorms and obstructions such as FG, BR and HZ. Other phenomena depend on augmentation.

The guide also lists points where automation is steadier than a person: it does not suffer from night adaptation, and it avoids the packing effect, in which an observer overestimates cloud coverage near the horizon. As a result it reports more broken and fewer overcast layers than an observer.

Augmentation

At select airports the automated system has input and oversight by certified weather observers or tower controllers. The handbook calls these augmented observations. Human observers report elements beyond the automated capability or judged operationally significant. The elements they add differ by airport, and AUTO is not used in augmented reports.

In the ASOS guide an observer logs onto the system through the operator interface device. A report with AUTO is unattended. When AUTO is missing, an observer was logged on, even if only some elements were added. That makes the presence or absence of AUTO a clue to how much of a report is instrument output. Remarks written by a person, covered in the remarks page, often show the augmentation.

A schematic report

The following report is schematic. It is built to show the structure of an automated observation and is not a real observation.

METAR KXXX 011153Z AUTO 18008KT 10SM CLR 12/08 A3001 RMK AO2

The station identifier and time come first, then AUTO, which tells the reader no human was involved. CLR in an automated report means that no clouds were detected below 12,000 ft by the ceilometer, not that the sky is empty. AO2 at the end identifies a station with a precipitation discriminator, and AO1 would change how rain and snow are read. A maintenance indicator at the end of a report is covered on the sensor status page.

In real reports

The Aviation Weather Handbook decodes a report for Pensacola, Florida: KPNS 030053Z 36005KT 10SM CLR 30/23 A2992 RMK AO2 SLP132 T03000233. It reads as wind from 360 degrees at 5 knots, visibility 10 miles, clear skies, temperature 30 and dew point 23 degrees Celsius, with the AO2 remark in place. Real reports from a given automated site carry AUTO or not depending on whether an observer is logged on.

Cloud and visibility values in such reports are averages, not snapshots, so a change seen from the cockpit may take minutes to show up in the next report.

Method and limits

  • The Aviation Weather Handbook chapter 24 (24.2 to 24.3) was read for observation types, ASOS elements, the six AWOS types, OMO behavior and time averaging.
  • The ASOS User's Guide read is the March 1998 edition. Its counts (about 500 commissioned systems), the 12,000 ft limit and the sensor list may have changed since. A later NWS or FAA document was not read.
  • The AIM chapter 7 section 1 and the Federal Meteorological Handbook No. 1 were consulted for context only, and no statement from them on ASOS cloud limits is quoted.
  • The schematic report is invented for illustration. The KPNS line is quoted from the handbook as an example of decoding.
  • Rules in other countries were not checked. Automated systems elsewhere may differ in sensors, averaging and coding.

Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).

Frequently asked questions

What is the difference between ASOS and AWOS?

ASOS is the national primary surface network run jointly by the NWS, FAA and DOD, and it issues METAR and SPECI. AWOS is described as similar but generally reporting fewer elements, with possibly fewer backup sensors. It produces a METAR every 20 minutes and no SPECI. Federal units belong to the FAA, others to the site owner.

Why does a METAR say AUTO?

AUTO marks an observation made by instruments and algorithms without human input or oversight. If a certified observer or tower controller augments the system, AUTO is not used. The report type is covered on the AUTO, COR and NIL page.

Can an automated station see every cloud?

No. The ASOS ceilometer looks straight up and reports to 12,000 ft in the sources read. It sees only what passes over the sensor, and the 1998 ASOS guide says a single ceilometer can miss some FEW events, which may be reported as CLR.

What are the six types of AWOS?

The Aviation Weather Handbook lists AWOS-A (altimeter only), AWOS-AV (altimeter and visibility), AWOS-1 (wind, temperature, dew point, altimeter, density altitude), AWOS-2 (adds visibility), AWOS-3 (adds precipitation accumulation and cloud height) and AWOS-4 (adds freezing rain to AWOS-3PT).

Is the voice broadcast the same as the METAR?

Not exactly. The Aviation Weather Handbook says the radio broadcast carries the one-minute observation, which can differ from the METAR seen online. Wind direction is in magnetic degrees on the radio and telephone, and in true degrees in the national network.

Sources

  1. Federal Aviation Administration (2024). Aviation Weather Handbook (FAA-H-8083-28A), chapter 24, Observations
  2. National Weather Service, NOAA (1998). Automated Surface Observing System (ASOS) User's Guide
  3. Federal Aviation Administration (2026). Aeronautical Information Manual, Chapter 7 Section 1, Meteorology
  4. Office of the Federal Coordinator for Meteorology (2019). Federal Meteorological Handbook No. 1 (FCM-H1-2019)