DU and SA: dust and sand in METAR and TAF
DU is widespread dust and SA is sand, both dry particles that reduce visibility. When the wind lifts them from the ground, the descriptors DR (below 2 m or 6 feet) and BL (at or above that height) give DRDU, DRSA, BLDU and BLSA. WMO-No. 782 reports DU and SA only with visibility of 5000 m or less, but drifting forms may appear at any visibility.
Key points
- DU is widespread dust in suspension; SA is sand raised by the wind.
- DR means drifting, below 2 m or 6 feet; BL means blowing, at or above that height.
- WMO-No. 782 reports DU and SA only with visibility of 5000 m or less, except drifting sand.
- FMH-1 and NWS Instruction 10-813 give BLDU and BLSA no intensity; CAP 746 lists them with one.
- VCBLDU and VCBLSA report blowing dust or sand in the vicinity.
- Slant visibility in dust is often worse than the reported surface value.

Two dry obscurations from the ground
DU and SA are the obscurations that come from the ground rather than from fire or water. They have more coded forms than smoke or haze, because the wind can hold them in suspension, lift them high or roll them along the surface. All of them are coded in the present weather group.
| Code | Meaning |
|---|---|
DU |
Widespread dust in suspension |
SA |
Sand |
DRDU |
Drifting dust, below 2 m (6 feet) |
DRSA |
Drifting sand, below 2 m (6 feet) |
BLDU |
Blowing dust, 2 m (6 feet) or more |
BLSA |
Blowing sand, 2 m (6 feet) or more |
VCBLDU |
Blowing dust in the vicinity |
What dust and sand are
FMH-1 defines dust as fine particles of earth or other matter raised or suspended in the air by the wind, which may have occurred at or far away from the station. It defines sand as particles raised by the wind to a height sufficient to reduce horizontal visibility. WMO-No. 782 describes DU as small dust particles raised from the ground that reduce visibility to 5000 m or less, and SA as the same effect from sand.
CAP 746 (section 4.76) describes DU as widespread dust in suspension and notes that it is rarely reported in the UK. In section 4.90 it adds that sand, in the UK, is typically used only with BL or DR. WMO-No. 782 explains the difference in size when it describes dust storms: dust particles are typically smaller than 0.08 mm and are lifted much higher than sand.
Drifting and blowing: DR and BL
The descriptors DR and BL separate dust or sand moved by the wind at the station by height. DR, drifting, stays below 2 m in WMO and UK rules, or below 6 feet in FMH-1. BL, blowing, reaches 2 m (6 feet) or more and reduces the visibility at eye level. FMH-1 allows DR and BL only with DU, SA and SN. The general rules for both descriptors are on the DR and BL page.
The difference matters for the visibility value. Drifting dust or sand lies under the eyes of the observer, so the reported visibility can stay high. Blowing dust or sand rises into the line of sight and cuts it.
The 5000 m limit and its exceptions
WMO-No. 782 states that DU and SA, except drifting sand, are reported only when visibility is 5000 m or less. Above 5000 m, FU, HZ, DU, SA and BR are not present by definition. CAP 746 (section 4.71) applies the same limit to dust. The same family of limits is explained on the HZ haze page and the FU smoke page.
US rules use 7 statute miles instead. FMH-1 reports obscurations when the prevailing visibility is less than 7 statute miles, but lists exceptions that may appear with any visibility, among them DRDU and DRSA. NWS Instruction 10-813 allows DRDU and DRSA in a TAF with P6SM when they are operationally significant. The rules for the value itself are on the visibility page.
Intensity: a conflict between sources
FMH-1 and NWS Instruction 10-813 state that BLDU, BLSA and BLSN take no intensity. WMO-No. 782 gives intensity only to precipitation and to dust storms and sandstorms, and DU and SA alone never take a sign.
CAP 746 Table 3 takes another line: BLSA and BLDU appear in the column of codes that may carry intensity. A UK report could therefore show a sign before blowing sand or dust, while a US report would not. The general rules are on the intensity and vicinity page.
In the vicinity
FMH-1 allows the vicinity prefix with BLDU and BLSA, among others, for phenomena between 5 and 10 statute miles from the point of observation. CAP 746 lists BLDU and BLSA in its vicinity list, within 8 km of the aerodrome, without intensity. VCBLDU therefore means a wall of blowing dust seen nearby but not at the station.
Why dust matters in flight
The FAA Aviation Weather Handbook (FAA-H-8083-28A, section 18.1.7) describes the conditions: surface winds of 15 knots or more are needed to lift dust, more over stony desert surfaces, and dust can rise thousands of feet. After sunset, cooling settles it at about 1,000 feet per hour without turbulence, while rain removes it quickly. The handbook warns that visibility can drop to zero in seconds and that slant visibility in dust is generally worse than the surface value, so an airfield may be hard to find from above even with 3 miles reported. Sand is heavier: section 18.1.8 notes that it mostly stays in the lowest 10 feet and rarely rises above 50 feet.
The FAA AIM adds that a ring of blowing dust may be the only visual clue of a dry microburst. Automated stations may not help: WMO-No. 782 notes that automatic systems may not detect DU or SA and may have trouble with BL and DR.
A schematic report
METAR LXXX 191300Z 27025G38KT 2500 BLDU SCT040 34/02 Q1006
It reads: wind from 270 degrees at 25 knots gusting 38, visibility 2500 m in blowing dust, scattered cloud at 4,000 feet, temperature 34 °C, dew point 2 °C. The strong wind and the dry air fit blowing dust. Small spinning columns of dust have their own code, explained on the PO dust whirls page.
In real reports
The "In real reports" box on this page shows the share of METARs in the NOAA Aviation Weather Center sample collected for this site that contain DU or SA. Both depend on dry ground and strong wind, so they are concentrated in desert and dry regions and in windy afternoons.
Method and limits
Definitions and rules are taken from FMH-1 (2019, sections 8.3.2 and 8.3.3, 8.5 and 12.6.8), WMO-No. 782 (2025 edition, obscurations, descriptors and their notes), CAP 746 (sections 4.71, 4.74, 4.76, 4.85, 4.90, Table 3 and the vicinity list), NWS Instruction 10-813 (October 2024, Appendix B) and the FAA AIM, chapter 7, section 1. The lifting, settling and slant visibility details come from the FAA Aviation Weather Handbook (FAA-H-8083-28A, sections 18.1.7 and 18.1.8), which is a training text rather than a coding standard. The sources disagree on intensity with BLDU and BLSA (none in FMH-1 and NWS Instruction 10-813, allowed in CAP 746 Table 3) and on the height limit (2 m or 6 feet); the page states both. The LXXX line is a schematic example, not a real report. The image shows blowing dust in Nevada; it is not linked to a specific report. The box counts DU and SA in the text of the METARs, so BLDU, DRSA and similar forms may be included depending on how the statistic key counts them.
Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).
Frequently asked questions
What does DU mean in a METAR?
DU means widespread dust: fine particles of earth or other matter raised or suspended in the air by the wind, at or away from the station. WMO-No. 782 reports it when it reduces visibility to 5000 m or less. It is an obscuration, coded in the present weather group.
What is the difference between DU and BLDU?
DU is dust already in suspension, which may have been raised far from the station. BLDU is dust being lifted from the ground by the wind at the station, to a height of 2 m (6 feet) or more, with reduced visibility. Drifting dust, below that height, is DRDU.
Can BLSA have an intensity sign?
The sources disagree. FMH-1 and NWS Instruction 10-813 code BLDU and BLSA without intensity. CAP 746 places BLSA and BLDU among the codes that can take intensity in UK reports. The rule that applies depends on the country of the station.
Why does DRSA appear with good visibility?
Drifting sand stays below eye level, so it does not reduce the visibility measured at 2 m. WMO-No. 782 excludes drifting sand from the 5000 m limit, and FMH-1 allows DRDU and DRSA at any visibility. NWS Instruction 10-813 allows them in a TAF with P6SM when operationally significant.
Is SA common in UK reports?
No. CAP 746 notes that in the UK sand is typically reported only with the descriptors BL or DR, and that widespread dust is rarely reported. Dust and sand codes are far more common in desert regions and in dry continental areas.
Sources
- World Meteorological Organization (2025). Aerodrome Reports and Forecasts: A Users' Handbook to the Codes (WMO-No. 782), 2025 edition
- UK Civil Aviation Authority (2023). CAP 746, Requirements for Meteorological Observations at Aerodromes
- Office of the Federal Coordinator for Meteorology (2019). Federal Meteorological Handbook No. 1, Surface Weather Observations and Reports (FCM-H1-2019)
- National Weather Service (2024). NWS Instruction 10-813, Terminal Aerodrome Forecasts (October 30, 2024), Appendix B
- Federal Aviation Administration. Aeronautical Information Manual, chapter 7, section 1
- Federal Aviation Administration (2024). Aviation Weather Handbook (FAA-H-8083-28A), chapter 18