MI, BC and PR: shallow, patches and partial fog

Tafrob editorial team · Updated · 5 min read

Short answer

MI, BC and PR are descriptors used only with fog. MIFG is shallow fog, lying in a thin layer near the ground; BCFG is fog patches spread randomly over the aerodrome; PRFG is fog covering a substantial part of the aerodrome while the rest is clear. All three can be reported while the prevailing visibility is 1000 m or more, because the fog does not cover the whole aerodrome or the observer's eye level.

Key points

  • MI (shallow), BC (patches) and PR (partial) are fog descriptors; WMO-No. 782 allows them only with FG.
  • MIFG is fog in a layer below about 2 m, or below 6 ft in US practice, so visibility at eye level stays at 1000 m or more.
  • BCFG is patches spread over the aerodrome at random; PRFG is fog over a substantial part of it, with the rest clear.
  • FG alone means visibility below 1000 m; when that is not true everywhere, the observer considers MI, BC or PR.
  • Only one descriptor is used per weather group, so MIBCFG is not valid.
  • Shallow fog can hide runway markings and lights even when the reported visibility is good.
Shallow ground fog lying over the airfield of Trenton-Mercer Airport in New Jersey
Photo: Famartin, CC BY-SA 4.0, via Wikimedia Commons

Three ways fog can fail to fill the aerodrome

Fog rarely covers an airport evenly. It forms first in hollows, along rivers and over grass, and it often lies in a layer too thin to reach the observer's eyes. The METAR code handles this with three descriptors that sit in front of FG:

Code Descriptor Meaning
MIFG MI, shallow Fog in a thin layer near the ground
BCFG BC, patches Patches of fog spread at random over the aerodrome
PRFG PR, partial Fog over a substantial part of the aerodrome, the rest clear

WMO-No. 782 states that each of the three is used only with FG. The codes appear in the present weather group, and FMH-1 states that only one descriptor is used in each group, so a combination such as MIBCFG is not valid.

Why fog has a visibility threshold

The descriptors make sense only against the rule for plain FG. CAP 746 states that FG is reported when the prevailing visibility is below 1000 m in all directions. When fog is present but the visibility at the observer's eye level is 1000 m or more, or when part of the horizon is clear, the observer considers MI, BC or PR instead.

This is why these codes so often appear next to good visibility:

METAR EGXX 060550Z 00000KT 9999 MIFG FEW003 04/04 Q1024
METAR EGXX 060620Z 00000KT 4000 BCFG SCT002 05/05 Q1024

Both lines are schematic. In the first, a thin layer of fog lies on the ground and the visibility at eye level is 10 km or more. In the second, patches of fog drift over the field and prevailing visibility has dropped to 4000 m, still well above the fog threshold. Plain fog is decoded on the FG fog page.

MIFG: shallow fog

WMO-No. 782 uses MI only with FG when the horizontal visibility is 1000 m or more but there is a layer between the ground and 2 m, the assumed eye level of the observer, in which the apparent visibility is below 1000 m. CAP 746 describes it as fog on the ground, in patches or as a continuous layer, less than 2 m deep, which is why the reported visibility is 1000 m or more.

US practice uses a different height. FMH-1 describes shallow fog as fog less than 6 feet deep. The two thresholds are close (2 m is about 6.6 feet) but not identical.

Shallow fog is an operational trap. WMO-No. 782 notes that it may obscure runway markings and lights. A pilot in the flare looks down through the layer at a shallow angle, and the runway can disappear even though the reported visibility is excellent.

BCFG: fog patches

WMO-No. 782 uses BC only with FG when patches of fog randomly cover the aerodrome. The reported visibility is 1000 m or more, but the observer can see areas where it is below 1000 m. CAP 746 adds that the patches are at least 2 m deep and spread irregularly, and that the visibility at any point depends on the nearest patch.

Because the patches are scattered, conditions change from one place to the next. A taxiing aircraft can pass in and out of fog several times, and visibility along the runway is not the same everywhere, which is one reason runway visual range is measured at several points on long runways.

PRFG: partial fog

WMO-No. 782 uses PR only with FG when a substantial part of the aerodrome is covered by fog while the remainder is clear. CAP 746 describes it as fog at least 2 m deep over a substantial part of the aerodrome, for example a single bank a few hundred metres wide, and notes that the visibility depends on how close the observer is to the edge of the bank.

The difference from BCFG is the shape of the fog. BC describes many patches scattered at random; PR describes one large area, often a bank that has rolled in from one side of the field.

The US depth rules

FMH-1 gives depth thresholds rather than relying on eye level alone. Shallow fog is less than 6 feet deep. Partial fog and patches are fog 6 feet or more but less than 20 feet deep, and FMH-1 notes that the sun or stars are often visible through it. FMH-1 also allows MIFG, BCFG and PRFG to be coded when the visibility is 7 statute miles or more, which is the US equivalent of reporting fog descriptors alongside 9999.

MI, BC and PR in a TAF

The descriptors can be forecast. NWS Instruction 10-813 includes MIFG in its matrix of weather allowed in NWS TAFs: it is forecast when the visibility at 6 ft above ground level is above the fog threshold while the apparent visibility in the fog layer is expected to be at or below it. BCFG and PRFG also appear in the NWS matrix, with patches of fog forecast to cover the airport randomly, or fog forecast over a substantial part of the airport while the remainder stays clear. Fog near the aerodrome rather than on it is coded VCFG, explained on the VCSH, VCTS and VCFG page.

In real reports

The "In real reports" box on this page shows how often MI, BC and PR appear in the METARs of the NOAA Aviation Weather Center sample collected for this site. The counts depend on the hours and the season covered by the sample, since these descriptors describe fog that is forming or clearing. Automated stations seldom report them: WMO-No. 782 notes limits on automatic observation of MI, BL and DR.

Method and limits

Definitions are taken from WMO-No. 782 (2025 edition), CAP 746 (sections 4.87, 4.88 and 4.91), FMH-1 (2019) and NWS Instruction 10-813 (October 2024). The sources use different depth thresholds: 2 m in WMO-No. 782 and CAP 746, 6 feet and 20 feet in FMH-1. The exact visibility fraction in the NWS footnotes for MIFG, BCFG and PRFG is unreadable in the text extraction of the PDF used here, so it is not quoted. The METAR lines are schematic examples with the placeholder EGXX, not real reports. The box counts the descriptors in the text of the METARs; it does not separate human from automated observations, and a sample collected over a short period may miss the seasonal peak.

Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).

Frequently asked questions

What does MIFG mean in a METAR?

MIFG is shallow fog. WMO-No. 782 defines it as fog in a layer between the ground and 2 m, the assumed eye level of the observer, where the apparent visibility is below 1000 m while the horizontal visibility at eye level is 1000 m or more.

What is the difference between BCFG and PRFG?

BCFG means patches of fog covering the aerodrome at random. PRFG means a substantial part of the aerodrome is covered by fog while the rest is clear. CAP 746 gives the example of a single bank a few hundred metres wide for PRFG.

Why does a METAR show BCFG with 9999 visibility?

Prevailing visibility is the value reached over at least half of the horizon, so patches of fog may leave it at 10 km or more. CAP 746 states that BCFG, PRFG and VCFG may be reported regardless of visibility, and FMH-1 allows MIFG, BCFG and PRFG with 7 statute miles or more.

Can MI, BC or PR be used with anything other than fog?

In WMO-No. 782, MI, BC and PR are used only with FG. Shallow, patchy or partial snow or mist are not coded with these descriptors; drifting snow uses DR instead.

Is MIFG dangerous for landing?

It can be. WMO-No. 782 warns that shallow fog may obscure runway markings and lights. A pilot in the flare can lose sight of the runway even though the visibility in the report, measured at eye level, is good.

Sources

  1. World Meteorological Organization (2025). Aerodrome Reports and Forecasts: A Users' Handbook to the Codes (WMO-No. 782), 2025 edition
  2. UK Civil Aviation Authority (2023). CAP 746, Requirements for Meteorological Observations at Aerodromes
  3. Office of the Federal Coordinator for Meteorology (2019). Federal Meteorological Handbook No. 1, Surface Weather Observations and Reports (FCM-H1-2019)
  4. National Weather Service (2024). NWS Instruction 10-813, Terminal Aerodrome Forecasts (October 30, 2024), Appendix B