The METAR present weather group: intensity, descriptor and phenomenon

Tafrob editorial team · Updated · 5 min read

Short answer

A present weather group is assembled left to right: intensity or proximity, then a descriptor, then one or more phenomena. +SHRA is heavy rain shower, -DZRA is light drizzle and rain, and VCTS is thunderstorm in the vicinity. Each independent type of weather gets its own group, and US reports carry no more than three groups.

Key points

  • The group is read in column order: intensity or proximity, descriptor, precipitation, obscuration, other.
  • No intensity symbol means moderate; a minus sign means light, a plus sign means heavy, and VC means in the vicinity.
  • Each type of weather gets its own group, separated by a space, and a US METAR carries no more than three.
  • Order rules differ slightly between FMH-1 and ICAO-based guidance, so do not rely on position alone.
  • Fog, mist, haze, smoke, dust and sand have visibility thresholds that decide whether they are coded at all.
Airport terminals and control tower under a heavy sky after a storm
Photo: 4300streetcar, CC BY 4.0, via Wikimedia Commons

How is a present weather group put together?

FMH-1 Table 12-2 organizes present weather into five columns, and a group is built by reading them in sequence: intensity or proximity, descriptor, precipitation, obscuration, and other. WMO-No. 782 Code table 4678 uses the same structure. The FMH-1 example is heavy rain showers, coded +SHRA: plus for heavy, SH for showers, RA for rain.

Column Codes Notes
Intensity or proximity - (light), none (moderate), + (heavy), VC (in the vicinity) No symbol means moderate
Descriptor MI, PR, BC, DR, BL, SH, TS, FZ One per group
Precipitation DZ, RA, SN, SG, IC, PL, GR, GS, UP IC is in FMH-1 but not in the WMO table
Obscuration BR, FG, FU, VA, DU, SA, HZ, PY PY is in FMH-1 but not in the WMO table
Other PO, SQ, FC, SS, DS Includes funnel cloud and tornado

For the full list of what each code means, see the METAR weather codes list.

What do the intensity and proximity symbols cover?

Intensity is not coded for every phenomenon. FMH-1 says intensity goes with precipitation types except IC, GR and UP, is not coded for blowing dust, sand or snow, and is only moderate or heavy for sandstorm and duststorm. WMO-No. 782 restricts intensity to precipitation, duststorm and sandstorm. CAP 746 notes that there are no international intensity definitions.

VC is separate. In the US, FMH-1 defines at the station as within 5 statute miles and vicinity as 5 to 10 statute miles. Weather beyond that goes in remarks, and precipitation not at the station but within 10 miles is coded VCSH. FMH-1 limits VC to TS, FG, SH, PO, BLDU, BLSA, BLSN, SS and DS, and says intensity symbols are not coded with VC. WMO-No. 782 describes vicinity as approximately 8 to 16 km from the aerodrome reference point, while CAP 746 says weather within about 8 km is reported as VC. See intensity and vicinity for more.

Which descriptors can go with which phenomena?

Only one descriptor is allowed in a group, and FMH-1 limits each one:

Descriptor Allowed with Example
MI, PR, BC FG only MIFG
DR, BL DU, SA, SN BLSN
SH RA, SN, PL, GS, GR -SHRA
TS Alone, or with RA, SN, PL, GS, GR TSRA
FZ FG, DZ, RA FZRA

Further FMH-1 rules: BR takes no descriptor, TS is not combined with SH, and FZ is not combined with SH. DR is used for material raised to less than 6 ft and BL for 6 ft or more. In CAP 746, shallow and low drifting mean under 2 m, and blowing means 2 m or more.

In what order are multiple phenomena written?

When several types occur at once, each gets its own group. FMH-1 section 8.5 gives the order: tornadic activity first, then thunderstorm with or without precipitation, then present weather in order of decreasing dominance, then left to right through the table columns.

CAP 746 describes a different order for UK reports: precipitation first, then obscuration, then other, for example +SHGS BLSN SQ, except that thunderstorm takes precedence over precipitation. So the two systems agree that thunderstorm comes first, but differ in the order of the remainder. Do not assume position implies strength unless the source rules say so.

Mixed precipitation is one group, not several. WMO-No. 782 shows SNRA, with the dominant type first. FMH-1 allows up to three types in a single group, in decreasing order of dominance, for example TSSNGS, and the intensity symbol then represents the total precipitation. CAP 746 shows -DZRA, RADZ, -SHRASN and +TSSNRAGS.

When is an obscuration coded at all?

Obscurations are only coded when they matter for visibility. FMH-1 says they are coded in the body when surface visibility is below 7 miles or when they are operationally significant, with exceptions: VA is always coded when observed, and low drifting dust, sand or snow, shallow fog, partial fog and patches of fog are coded regardless.

The ICAO thresholds are metric. WMO-No. 782 says FU, HZ, DU, SA and BR are reported only when visibility is 5000 m or less. It defines mist as visibility reduced by water droplets to 1000 m to 5000 m, and fog as below 1000 m. CAP 746 states the same limit for fog and adds that FZFG also needs a temperature below 0 degrees C, while shallow fog and mist apply when visibility is 1000 m or more. FMH-1 uses different sizes in the US: fog is below 5/8 statute mile and mist is 5/8 to under 7 miles. See BR mist and FG fog.

Other definitions in the sources: FMH-1 sets drizzle drops under 0.02 in (0.5 mm), and WMO-No. 782 and CAP 746 set 5 mm as the largest stone size that separates GR from GS.

Thunderstorms, funnel clouds and ash

TS is a descriptor that can stand alone. WMO-No. 782 says it is used whenever thunder is heard or lightning is detected at the aerodrome within the 10 minutes before the observation, and CAP 746 says the same for thunder, adding that lightning seen without thunder is likely beyond 8 km and is not reported. See TS thunderstorm.

FMH-1 codes a tornado or waterspout as +FC and a funnel cloud as FC. Volcanic ash, VA, is always coded when observed, and UP, for unknown precipitation, is only used by automated stations. WMO-No. 782 codes missing weather as two slashes. For the weather that ended recently, see recent weather RE.

Decoding real examples

US example from the Aviation Weather Handbook:

METAR KOKC 011955Z AUTO 22015G25KT 180V250 3/4SM R17L/2600FT +TSRA BR OVC010CB 18/16 A2992
  • +TSRA: heavy thunderstorm with rain, built as intensity, descriptor, phenomenon.
  • BR: mist, in its own group after the thunderstorm group.

ICAO example from WMO-No. 782:

SPECI LUDO 211025Z 31015G27KT 280V350 4000 1400SW R24/P2000 +SHRA FEW005 FEW010CB SCT018 BKN025
  • +SHRA: heavy rain showers.

Canadian example from NAV CANADA:

METAR CYXE 292000Z CCA 30015G25KT 3/4SM R33/4000FT/D -RA BR BKN008 OVC040 21/19 A2992
  • -RA BR: light rain and mist, with the dominant phenomenon first. NAV CANADA describes a present weather group as a phenomenon with up to two qualifiers, intensity or proximity and descriptor.

Common mistakes

  • Reading no sign as light. No sign means moderate.
  • Looking for NSW in a METAR. It belongs to forecasts; in a METAR the group is omitted.
  • Adding intensity to VC groups. FMH-1 says VC takes no intensity symbol.
  • Splitting mixed precipitation into two groups when the rules call for one.
  • Mixing US and ICAO fog and mist thresholds.

This page is educational and is not a source for operational weather. For the wider structure, see how to read a METAR.

Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).

Frequently asked questions

What does the plus sign mean in +RA?

It means heavy. A minus sign means light, and no sign means moderate. FMH-1 and WMO-No. 782 use the same three levels. Intensity is applied to precipitation, and WMO-No. 782 also allows it for duststorm and sandstorm, so +RA is heavy rain.

How many weather groups can a METAR have?

FMH-1 says US METAR and SPECI reports contain no more than three present weather groups. CAP 746 also allows up to three groups in UK reports.

What does a missing weather group mean?

It usually means no reportable weather. CAP 746 states that the UK does not use NSW in a METAR, and the group is simply omitted when there is no significant weather. A group of two slashes in WMO-No. 782 means weather is missing, not absent.

Can I combine rain and snow in one group?

Yes, but only as precipitation types in a single group, dominant type first. WMO-No. 782 shows SNRA, and FMH-1 allows up to three precipitation types in one group, such as TSSNGS. One intensity symbol then covers the total precipitation.

Sources

  1. Office of the Federal Coordinator for Meteorology (2019). Federal Meteorological Handbook No. 1 (FCM-H1-2019)
  2. Federal Aviation Administration (2024). Aviation Weather Handbook (FAA-H-8083-28A)
  3. World Meteorological Organization (2025). Aerodrome Reports and Forecasts, A Users' Handbook to the Codes (WMO-No. 782)
  4. UK Civil Aviation Authority (2023). CAP 746, Requirements for Meteorological Observations at Aerodromes
  5. NAV CANADA. Aviation Weather Services Guide