FU: smoke in METAR and TAF
FU is smoke: a suspension of small particles produced by combustion, from wildfires, industry or other burning. Under WMO-No. 782 and CAP 746, FU is reported only with visibility of 5000 m or less. Smoke is dry, so it may be reported below 1000 m only when the air is not close to saturation. A smoke layer above the station goes in the remarks, as in RMK FU BKN020.
Key points
- FU is smoke: small particles produced by combustion, from fires or industry.
- WMO-No. 782 and CAP 746 report FU only when visibility is 5000 m or less.
- Below 1000 m, FU is reported only if relative humidity is not above about 90% and there are no droplets.
- A smoke layer aloft goes in the remarks, for example RMK FU BKN020.
- Smoke far from its source can turn into haze, and the code may change from FU to HZ.
- Smoke contains toxic gases such as carbon monoxide, and slant visibility through it can be poor.

Smoke as an obscuration
FU comes from the French word fumée. Like haze and mist, it is an obscuration: the particles stay in the air instead of falling. Wildfire seasons have made it a common code in some regions, sometimes for days at a time. It is coded in the present weather group.
| Code | Meaning |
|---|---|
FU |
Smoke |
HZ FU |
Haze and smoke |
RMK FU BKN020 |
Broken smoke layer aloft, based at 2,000 feet |
FU BKN000 |
Surface based smoke hiding part of the sky (remark) |
HZ |
Haze: dry particles, often aged smoke |
What smoke is
FMH-1 defines smoke as a suspension in the air of small particles produced by combustion. WMO-No. 782 gives the same idea and names the sources: industry or wildfires, for example. CAP 746 (section 4.93) adds what an observer sees: smoke frequently gives the atmosphere a grey or blue hue.
The FAA Aviation Weather Handbook (FAA-H-8083-28A, section 18.1.4) uses the FMH-1 wording and lists fires, industrial burning and other sources. It adds a point that matters to crews: smoke can reduce visibility to zero, and many of its compounds are toxic or irritating, the most dangerous being carbon monoxide.
The 5000 m limit
WMO-No. 782 states that FU is reported only when visibility is 5000 m or less. Its notes make the rule general: above 5000 m, FU, HZ, DU, SA and BR are not present by definition, and a visibility from 5001 m to 5999 m is encoded as 5000 without these phenomena. CAP 746 (section 4.71) gives the same limit for UK reports.
US practice is wider. FMH-1 reports obscurations, except a few special cases, when the prevailing visibility is less than 7 statute miles, or when the observer considers them operationally significant. The FAA AIM sums up the reason: when visibility is under 7 miles, the report names the condition that obscures it, such as fog, haze or smoke. The rules for the value itself are on the visibility page.
Smoke, fog or haze: the humidity test
Smoke is dry, so the same humidity check used for haze applies. CAP 746 appendix B asks the observer to consider dust, smoke or haze when visibility is 5000 m or less, relative humidity is below 95% and the spread between temperature and dew point is more than 1 °C. The wet obscurations are on the BR mist page and the FG fog page.
Dense smoke can bring the visibility below 1000 m, the usual threshold for fog. WMO-No. 782 and CAP 746 allow FU in that case only if there are no suspended water droplets and relative humidity is not above about 90%. A very low visibility with humid air is treated as fog, even near a fire.
From smoke to haze
Smoke changes as it travels. FMH-1 and the FAA Aviation Weather Handbook both note a transition to haze when the particles have travelled 25 to 100 miles (40 to 160 km) or more, the larger ones have settled and the rest are spread widely. A station far downwind of a wildfire may therefore report HZ for the same smoke that a station near the fire reports as FU. The FAA AIM uses both codes together: a PIREP example reads FV03SM HZ FU, flight visibility 3 miles in haze and smoke. The dry counterpart is on the HZ haze page.
Smoke layers aloft
Smoke is often lifted above the surface, leaving the station visibility good. In that case it does not go in the present weather group. FMH-1 (section 12.7.1) places obscurations aloft in the remarks, with the phenomenon, the sky cover and the height. The FAA AIM gives the example RMK FU BKN020, a broken layer of smoke aloft based at 2,000 feet.
The same format is used for surface based smoke that hides part of the sky. The FAA AIM reads FU BKN000 as smoke obscuring five to seven eighths of the sky; the height 000 marks a layer at the surface.
Why smoke matters in flight
The FAA Aviation Weather Handbook (section 18.1.4) explains that smoke and haze near the surface often thin during the day, when heating mixes them through a deeper layer, but they clear more slowly than fog: fog evaporates, while smoke has to be carried away by moving air. Under a thick cloud layer, visibility may improve little all day. As with haze, slant visibility through a smoke layer can be much worse than the reported horizontal value, and the FAA AIM notes that runway visual range sensors also respond to smoke.
Examples
A schematic WMO style METAR shows smoke from a nearby fire:
METAR LXXX 191500Z 24008KT 3000 FU SCT040 29/09 Q1012
It reads: wind from 240 degrees at 8 knots, visibility 3000 m in smoke, scattered cloud at 4,000 feet, temperature 29 °C, dew point 9 °C. The large spread matches a dry obscuration.
A schematic US line shows smoke aloft with no restriction at the surface:
METAR KXYZ 191553Z 21006KT 10SM FEW250 27/08 A2998 RMK AO2 FU BKN060
In real reports
The "In real reports" box on this page shows the share of METARs in the NOAA Aviation Weather Center sample collected for this site that contain FU. Smoke depends on wildfires and on wind, so the share can jump during a fire season and fall close to zero a week later.
Method and limits
Definitions and rules are taken from WMO-No. 782 (2025 edition, obscurations and their notes), CAP 746 (sections 4.71 and 4.93 and appendix B), FMH-1 (2019, section 8.3.2 and section 12.7.1) and the FAA AIM, chapter 7, section 1. The toxicity, clearing and transition descriptions come from the FAA Aviation Weather Handbook (FAA-H-8083-28A, section 18.1.4), which is a training text rather than a coding standard. WMO-No. 782 and CAP 746 limit FU to visibility of 5000 m or less, while US reports can show it up to less than 7 statute miles; the page gives both. The FV03SM HZ FU, RMK FU BKN020 and FU BKN000 groups are quoted from the FAA AIM; the LXXX and KXYZ lines are schematic examples, not real reports. The image shows wildfire smoke in California; it is not linked to a specific report. The box counts FU in the text of the METARs; mixed groups and remarks may be included depending on how the statistic key counts them.
Training and reference only. For flight planning, always use official briefing sources (your national weather service, AIS or approved provider).
Frequently asked questions
What does FU mean in a METAR?
FU means smoke, from the French word fumée. It is a suspension in the air of small particles produced by combustion, such as wildfires or industrial burning. It is an obscuration, not precipitation, and it is coded in the present weather group.
Why is FU not reported with 10 km visibility?
WMO-No. 782 states that above 5000 m the obscurations FU, HZ, DU, SA and BR are not present by definition. A European METAR with visibility above 5000 m therefore carries no FU, even if smoke can be smelt or seen. US rules allow obscurations up to less than 7 statute miles.
What does RMK FU BKN020 mean?
It means a broken layer of smoke aloft, based at 2,000 feet. FMH-1 and the FAA AIM place layers of obscuration that are not at the surface in the remarks, with the phenomenon, the amount and the height, so they do not appear in the present weather group.
What is the difference between FU and HZ?
Both are dry obscurations. FU is smoke, usually close enough to its source to be identified as smoke. FMH-1 notes that smoke which has travelled 25 to 100 miles or more, after the larger particles have settled, can take on the look of haze, and the observer may then report HZ.
Can FU be reported with visibility below 1000 m?
Yes, with a condition. WMO-No. 782 and CAP 746 allow it when there are no suspended water droplets and the relative humidity is not above about 90%. If the air is close to saturation, the observer considers fog instead.
Sources
- World Meteorological Organization (2025). Aerodrome Reports and Forecasts: A Users' Handbook to the Codes (WMO-No. 782), 2025 edition
- UK Civil Aviation Authority (2023). CAP 746, Requirements for Meteorological Observations at Aerodromes
- Office of the Federal Coordinator for Meteorology (2019). Federal Meteorological Handbook No. 1, Surface Weather Observations and Reports (FCM-H1-2019)
- Federal Aviation Administration. Aeronautical Information Manual, chapter 7, section 1
- Federal Aviation Administration (2024). Aviation Weather Handbook (FAA-H-8083-28A), chapter 18